FANDOM


PART I--TURN YOUR INGREDIENTS INTO A BALL OF PUTTYEdit

BUBBLE PUTTY Part I by Rick Findley02:23

BUBBLE PUTTY Part I by Rick Findley

part ii--just add hot water, stir, add more water and make eco/kid friendly, non-toxic big (not giant) bubblesEdit

Bp2

Place the Putty ball in 1 cup (or 250ml) of water. Use at least a 2 cup Pyrex measuring cup

Bp1

Full 1 liter amount. Best to be stored and kept in a plastic bag. Otherwise, like Play-Doh, it will eventually dry out.





Bp2A

Place in microwave oven along with the stir stick you are using.

Bp3

Heat in micro for 1 1/2 minutes and remove then begin to stir







Bp5

Place contents inside larger container and continue to sitr until the Putty ball is fully dissolved (1-2 minutes usually)

Bp4

As you stir it will start foaming.....

Bp7

Your pH should be within range since you have already added citric acid and baking soda. Important note: sometimes a little bit of the ingredients are lost in the batching of the Putty version of RAD, usually the Jlube is the only ingredient lost that is noticeable. If you are not getting good results after adjusting the pH add just a very tiny bit more JLube to make up for what may have been lost.

Bp6

Stir in 3 more cups of room temperature water to make approx. 1 liter of putty juice. Skim off the extra foam if desired OR let set until it disappears.

Ad blocker interference detected!


Wikia is a free-to-use site that makes money from advertising. We have a modified experience for viewers using ad blockers

Wikia is not accessible if you’ve made further modifications. Remove the custom ad blocker rule(s) and the page will load as expected.